Induction-dynamics ID1.w Manual do Utilizador descarregar pdf (Página 9)

Audio Perfection Realized ™

6. If you cannot screw into a wall stud, use 4 dry wall anchor bolts that spread out behind

the drywall. Select grommets that t snugly around the bolts you have chosen. Be sure to

put a metal washer between the head of the bolt and the grommet.

Installing the Faceplate

1. Attach the speaker wires to the terminal block on the back of the faceplate, observing the

proper polarity (red to red and black to black). To make connections, solder or crimp with

high pressure the insulated fork terminals provided in your parts packet. Soldering is best.

You will need to connect the right or left signal wire to the top half of the ID1. Connect the

bottom halves of the ID1s to your subwoofer amplier.

2. Position the speaker faceplate over the easy-mount box. Be careful to route the speaker

wire so it is not between the bottom of the box and a cage, or between the top ot the box

and the faceplate. If necessary, the wire may run alongside a cage. Screw in the faceplate

mounting bolts, gently tightening each one a little at a time, until the faceplate is moder-

ately snug. DO NOT TIGHTEN THE BOLTS ANY FURTHER. The rubber gasket provides

the seal.

3. Replace any shims (mentioned earlier) in their proper location. Use the grille mounting

ange driver to screw in the grille mounting anges. The grille mounting anges should be

used even if the grilles are not, as this gives the loudspeakers a nished appearance.

4. Attach the cloth grille by carefully pressing it into the grille mounting anges.

Connecting to an Amplier

1. Be sure the amplier is turned off to avoid damage to the speakers.

2. Connect the speaker wires to the speaker outputs on your amplier. Observe proper

polartity (red to red and black to black).

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sem comentários

Induction-dynamics ID1.w Manual do Utilizador Página 9